Table 30: SNE1100x, SNE1050x, and SNE110Lx network engines
Specification Description
Memory 16 GB flash nonvolatile memory for operating system, configuration data, and operations data
storage and backup
2 GB SDRAM for operations data dynamic memory
Supported
integrations
BACnet/IP, BACnet/SC, BACnet MS/TP, N2 Bus, LonWorks, Modbus, KNX, M-Bus, Zettler Fire, MQ
Telemetry Transport (MQTT), OPC UA
Tyco C•CURE 9000-victor video management, Simplex FACU, Molex Lighting Control, Cree
SmartCast Lighting Control
Note: The SNE110Lx model supports one IP device integration, but does not support the
N2 Bus or LonWorks network interface.
Network and Serial
interfaces
One Ethernet port; 1000/100/10 Mbps; 8-pin RJ45 connector
One FC port (RJ12 6-pin port; connects with 1.5 m [4.9 ft] RJ-12 field bus cable)
One optically isolated RS-485 port; with a removable 4-pin terminal block
Three USB ports (one Micro-B port, and two USB A ports). All support USB 2.0 and Open Host
Controller Interface [Open HCI] specification; Micro-USB port currently inactive
Transmission speeds Ethernet communication: 100 or 10 Mbps
The network engine resides and interoperates on a 1 Gbps network, but does not itself
transmit at 1 Gbps.
Optically isolated, serial communication (FC Bus): 76,800, 38,400, 19,200, 9600, or 1200 bps
(selectable)
Ambient temperature
conditions
Operating: 0°C to 50°C (32°F to 122°F)
Non-Operating: -40°C to 70°C (-40°F to 158°F)
Ambient humidity
conditions
Storage: 5% to 95% RH, 30°C (86°F) maximum dew point conditions
Operating: 10% to 90% RH, 30°C (86°F) maximum dew point conditions
Housing Black Polycarbonate and Acrylonitrile butadiene styrene (ABS) blend
IP protection class: IP20
UL flammability rating: UL94-5VB
Mounting On flat surface with screws on three mounting clips or a single 35 mm DIN rail
Dimensions (Height x
Width x Depth)
190 mm x 125 mm x 45.5 mm (7.48 in. x 4.92 in. x 1.75 in.)
Weight 0.387 kg (0.852 lbs)
Compliance United States: UL Listed, File E107041, CCN PAZX, UL 916, Energy Management Equipment; FCC
Compliant to CFR47, Part 15, Subpart B, Class A
Canada: UL Listed, File E107041, CCN PAZX7, CAN/CSA C22.2 No. 205, Signal Equipment;
Industry Canada Compliant, ICES-003
Europe: CE Mark – Johnson Controls, Inc. declares that this product is in compliance with the
essential requirements and other relevant provisions of the EMC Directive.
Australia and New Zealand: RCM Mark, Australia/NZ Emissions Compliant
BACnet International: BTL 135-2020 Listed B-BC/B-RTR/B-BBMD, Protocol Revision 18
FIPS 140-2 Level 1: Compliant and certified with Federal Information Processing Standard;
https://csrc.nist.gov/Projects/cryptographic-module-validation-program/Certificate/3389
United Kingdom: Johnson Controls declares that this product is in compliance with
Electromagnetic Compatibility Regulations, The Electrical Equipment (Safety) Regulations, and
Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment
Regulations.
The performance specifications are nominal and conform to
acceptable industry standard. For application at conditions
beyond these specifications, consult the local Johnson
Controls® office. Johnson Controls, Inc. shall not be liable
SNE Installation Guide26
To Next Page
Loading...
