167
GEARCASE
REMOVAL AND INSTALLATION
9
REMOVAL AND
INSTALLATION
Removal
Remove the propeller from the gearcase. Inspect
the condition of the propeller hub.
Drain the gearcase by first removing the oil level
plug, then the oil fill/drain plug.
Remove six screws attaching gearcase to exhaust
housing.
Separate gearcase and exhaust housing to
expose the shift rod connector. Remove the upper
connector screw.
Remove gearcase from the exhaust housing and
place in a suitable holding fixture.
WARNING
During service, the outboard may drop
unexpectedly. Avoid personal injury;
always support the outboard’s weight with
a suitable hoist or the tilt support bracket
during service.
TYPICAL
1. Oil level plug
2. Oil fill/drain plug
COA3264
32396
1
2
1. Screws 32397
1. Upper screw, shift rod connector 32566
1
1
To Next Page
Loading...
Need help?
General
