Section 8 Functions of the ECDIS (Option) 8-24
Mode change by the operation:
In the following cases, the motion/bearing mode will be automatically changed from the current mode
to another one.
• From [TM] mode to [Free] mode:
- When the own ship goes exceeding the display limit of the screen by scrolling the chart.
- When an area outside of the own ship range was displayed by loading charts or clicking the
[Jump] button in the [My Port List] dialog box.
• From [RM] mode to [Free] mode:
- When the own ship goes exceeding the display limit of the screen by scrolling the chart.
- When an area outside of the own ship range was displayed by loading charts or clicking the
[Jump] button in the [My Port List] dialog box.
• From [Free] mode to [TM] mode:
- When the [Home] button was clicked on,
the rotation in the Free mode is retained after changing to the TM mode.
Note
H UP, WPT UP, C UP are valid only the chart scale is not lower than 1/5,000,000.
To Next Page
Loading...
