Section 10 Route Monitoring 10-2
Limit check at the start of route route monitoring
The limit check is automatically executed at the start of route monitoring.
At this time, if a turning radius error ("The straight route cannot be created.") is detected, return
the route to unload and the following popup will be displayed.
Automatic safety checking after loading a route
When a route file is loaded, safety checking is executed automatically.
When an error is detected, the [Safety Contour Alert] object is displayed in red and [Navigational
Hazard Alert] and [Area Alert] are highlighted in yellow.
4 Select a WPT to which the ship is to travel. A WPT can be selected automatically or
manually.
[Automatic selection]
The nearest WPT from the own ship’s position is selected automatically.
1) Open the next WPT list by clicking on the [To WPT] combo box.
2) Select [AUTO Select].
[Manual selection]
Select a WPT manually.
1) Open the next WPT list by clicking on the [To WPT] combo box.
2) Click on a required WPT.
10.1.2 Ending route monitoring
1 Click on the [Menu] button on the left toolbar.
The menu is displayed.
2 Click on the [Route Monitoring] button on the menu.
The [Route Monitoring] dialog box appears.
3 Click on the [Route] combo box.
4 Click on [UNLOAD].
To Next Page
Loading...
