JRC JMR-7225-6X - Preparation; Setting the Cursor Mode to AUTO Mode; Setting Vector; Vector Modes

6-15 Section 6 Target Tracking and AIS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
6.4 Preparation
6.4.1 Setting the Cursor Mode to AUTO Mode
If the cursor mode is set to the AUTO mode, various TT/AIS functions can be executed quickly.
1 Click on the [AUTO] (cursor mode selection) button on the left toolbar.
The cursor mode changes to the AUTO mode.
The [AUTO] mode performs operation in accordance with the object at the cursor position when
clicked.
For the details, refer to "3.13 Cursor AUTO Mode".
6.4.2 Setting Vector
A vector to represent a target's predicted position can be presented in the True vector or Relative
vector mode. In each mode, a Vector Length can be freely changed for a time interval of 1 to 120
minutes.
6.4.2.1 Vector modes
Different vector modes can be used as described below according to the purpose.
To perceive the true state of the target: True Vector
To perceive the closest approach point of the target: Relative Vector