11-3 Section 11 Monitoring a Dragging Anchor
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
付録
4 Select the initial position of the center position of the dragging anchor monitoring
circle from the [Watch] button.
Change the initial position of the center position of the dragging anchor monitoring circle to
the anchor position. The value of [Anchor 1] [Anchor 2] can be set in [Service] - [Installation] -
[System Configuration] - [CCRP].
When you press the [Anchor 1] and [Anchor 2] buttons, coordinates are displayed at
[Anchor Position] (center of the dragging anchor monitoring circle).
5 Enter the size of the dragging anchor monitoring area.
[Radius] (Radius of the dragging anchor monitoring circle)
Input range
10 to 1500 m
To Next Page
Loading...
