Section 13 Operating a Chart (option) 13-28
3 Click on the row of the chart to be displayed from the C-MAP chart list.
The chart is selected.
4 Click on the [Show] button.
The selected chart is displayed at the center of the screen and a red line is displayed at the cell
boundary.
The updated object is displayed in highlight mode.
5 To reset the updated chart to the pre-update state, select two or more target charts
from the list and click on the [Reject] button.
When the [Reject] button is clicked on, the automatic update of the chart is rejected and the
chart is reset to the pre-update state.
6 Close the [Check Applied C-MAP Updates] dialog.
The red line at the cell boundary is cleared and the highlighted display of the updated object
also terminates.
The following objects can not be rejected with C-MAP.
・Depth area
・Dredged area
・Floating dock
・Hulk
・Land area
・Pontoon
・Unsurveyed area
Note
The [Check Applied C-MAP Updates] dialog is displayed only when only one check is ON in
C-MAP Ed 3 Database of [View-Option] - [Chart Common].
Otherwise, this dialog is not displayed.
When multiple checks are ON for C-MAP Ed3 Database in [View-Option] - [Chart Common], clicking
[Menu] - [Chart] - [Check Applied C-MAP Updates] opens the popup shown below and [Chart
Common] dialog.
To Next Page
Loading...
