JRC JSS-2500 - Selecting Tx Meters

Settings & Registrations
5-7
5.3.4 Selecting Tx meters
The meter displayed in the status display indicates the strength of the received signal (S meter).
However, it can also indicate one of Tx power, antenna current, PA voltage, PA current or key
information during transmission.
■ Procedure ■
1
1
1
.
.
.
Press the MENU key, and through
hierarchical menus, select 7.3 My
controller.
The screen as shown at right is displayed.
2
2
2
.
.
.
Move the cursor to 4. Tx meter with the
numeric keypad or jog dial.
3
3
3
.
.
.
Press ENT, and select the meter type
with the jog dial.
The selectable meters are as follows:
 PWR .... Tx power
 Ia ........ Antenna current
 Vc ....... PA voltage
 Ic ......... PA current
 Key…….Key information*
* When keying during the ARQ
communication, the Key is indicated
regardless of this setting.
4
4
4
.
.
.
Press ENT to confirm the selection.
The setting is complete.
7.3)My controller
1.LCD adjustment
2.Sound
3.User key assign
4.Tx meter :PWR
5.Data transfer
6.Menu shutdown :10min
7.CH search ref :40
8.Frequency digits :7 only
7.3)My controller
1.LCD adjustment
2.Sound
3.User key assign
4.Tx meter :PWR
5.Data transfer
6.Menu shutdown :10min
7.CH search ref :40
8.Frequency digits :7 only
7.3)My controller
1.LCD adjustment
2.Sound
3.User key assign
4.Tx meter :Ia
5.Data transfer
6.Menu shutdown :10min
7.CH search ref :40
8.Frequency digits :7 only
7.3)My controller
1.LCD adjustment
2.Sound
3.User key assign
4.Tx meter :Ia
5.Data transfer
6.Menu shutdown :10min
7.CH search ref :40
8.Frequency digits :7 only