Operation
4-8
4.2.3 Communicating in radiotelephone mode
Use the handset to communicate in radiotelephone mode.
■ Procedure ■
1
1
1
.
.
.
When operating on a controller without
access rights (OCC is displayed), press the
jog dial to obtain the access rights.
Unless the controller with access rights is being
used, the access rights are acquired and the OCC
display on the screen disappears.
2
2
2
.
.
.
Press the TEL key.
The communication mode is set to TEL and
the previous frequency (or the default
frequency at just after turning on) is set.
Pressing the TEL key again turns the
power to the PA on and off.
If the power to the PA is on, ON is displayed
as shown at right.
3
3
3
.
.
.
Set the frequency for making calls in
radiotelephone mode.
- When setting a frequency, the screen
becomes operating display as shown
at right.
- The frequency is set on the receiving
status in the status display or the
operating display. For details, see
"4.3.1 Setting the communication
frequencies" and "4.3.2 Setting the
communication channels".
- See the frequency for making calls
in the appendix "11.4 ITU channel
list (TEL/CW/TLX)".
4
4
4
.
.
.
Adjust the volume of the loudspeaker by
turning the volume control.
5
5
5
.
.
.
Turn the RF GAIN control to an appropriate
reception level.
TEL
ITU- 402
ON
ID 431001234 23:59(UTC)
Pos 89ﾟ59.0123'N
179ﾟ59.6789'E@23:59
S
IG
12 -S N2
RX
4360.00
kHz
TX
4068.00
kHz
D
UP
W
KR
2
4
6
8
12
16
A COMM
Communicating on
TEL Rx: 4360.00/Tx: 4068.00kHz
Tip)Use FUNC to change op area.
[HLD][END]
G
PS
TEL ITU- 401
4357.00
4065.00
RX kHz
TX kHz
D
UP
WKR scan bands:
2 4 6 8 12 16MHz
ON
ID 431001234 23:59(UTC)
Pos 89ﾟ59.0123'N
179ﾟ59.6789'E@23:59
SIG
12 -S N2
NonDST: +
DROBOS: +
EdtDST: +
M
ENU
M
ENU
1
2
3
M
ENU
G
PS
Note
To Next Page
Loading...