JRC JSS-2500 - Function Screen and Key Operations

Names and Functions
2-7
2.2.3 Function screen and key operations
The functions assigned to the number keys are temporarily enabled by pressing the FUNC
key in the status display or holding down the FUNC key and pressing the number key.
1. Indicates the enabled number key and its
function when the FUNC key is pressed in
the status display. Pressing the number
keys here operates the function for that
key as shown at the right.
1
CLAR : Displays the clarifier adjustment menu
2
SCAN : Displays the scan menu
3
NR : Displays the noise reduction menu
4
ATT : Displays the attenuation menu
5
AGC : Displays the AGC menu
6
SP : Turns the built-in loud speaker on or off
7
N/A : PRN is valid only on specific menus.
8
TEST : Displays the self-diagnosis menu
9 : Displays the Tx power reduction menu
0
Tst C all : Displays the DSC test call menu
FuncCncl : Closes this screen
2. Indicates that pressing ENT enables or disables the use of the jog dial to change the frequency
and channel in the status display.
- During the operating display mentioned above, the function screen is not appeared.
In this case the FUNC key alone is available to select the screen. However note
that the holding down the FUNC key and pressing the number key is also valid.
- In the following situations the function assigned to the function key cannot be used.
Equipment
status
1
CLAR 2SCAN 3NR 4ATT 5AGC 6SP 7PRN 8TEST 9
P
WR
R
DC
0
TEST
CALL
DSC mode
● ●
While printing
● ● ● ● ● ● ● ● ● ●
During
self-diagnosis
● ● ● ● ● ● ● ● ● ●
While
scanning
● ● ●
While BAM alert
screen is
displayed
● ● ● ● ● ● ● ● ● ●
Func mode key list
Ten key matrix
Concerned other keys
ID 431001234 23:59(UTC)
Pos 89ﾟ59.0123'N
179ﾟ59.6789'E@23:59
TEL Rx: 4146.00/Tx: 41416.00kHz
1:CLAR 2:SCAN 3:NR
4:ATT 5:AGC 6:SP
7:N/A@STBY 8:TEST 9:PWRRDC
FuncCancel 0:TESTCALL ---
ENT : CH dial op valid/invalid
G PS
1
2
Note
PWR
RDC