Settings & Registrations
5-13
5.5 Advanced settings for DSC/WKR
The following describes the procedure for the advanced DSC settings such as automatic
acknowledgement, as well as setting the watch frequency of the watch keeping receiver.
■ Menu screen ■
Press the MENU key, and through
hierarchical menus, select 7.5 DSC/WKR
condition.
The following describes the procedures from
this screen. Note that the screen at right
shows factory default settings.
5.5.1 Automatic acknowledgement
While the automatic acknowledgement is set to ON, and no menu is displayed and there is no
active procedure, if either one of the individual calls below is received, the acknowledgement is
sent automatically.
Safety test call
Safety position request call
Routine polling call
Individual call requesting communication without valid frequency (*)
(*) In this case, the “unable to comply” acknowledgement is sent.
■ Procedure ■
1
1
1
.
.
.
Move the cursor to 1. Automatic ACK,
and press ENT.
The screen as shown at right is displayed.
2
2
2
.
.
.
Set the call setting targeted for
automatic acknowledgement to ON.
5.5.2 Setting DSC watch frequency
Set the frequency to watch on the WKR (DSC watch keeping receiver).
■ Procedure ■
1
1
1
.
.
.
Move the cursor to 2. WKR scanning
FRQ, and press ENT.
The screen as shown at right is displayed.
2
2
2
.
.
.
Press ENT, and set another frequency in
addition to 2187.50 kHz and 8414.50 kHz to
ON.
In accordance with the SOLAS Convention, 2187.50 kHz and 8414.50 kHz cannot
be turned OFF.
Note
7.5.1)Automatic ACK
1.Test call :ON
2.Position RQ call :OFF
3.Polling call :ON
4.Individual call :ON
0.Back
7.5)DSC/WKR condition
1.Automatic ACK
2.WKR scanning FRQ
3.DSC alert setting
4.Medical use :OFF
5.Neutral use :OFF
6.Group ID
7.Inactivity timeout
8.DSC call list
7.5.2)WKR scanning FRQ
1.Registration
- CH1 2187.50kHz :(Const)
- CH2 4207.50kHz :OFF
- CH3 6312.00kHz :ON
- CH4 8414.50kHz :(Const)
- CH5 12577.00kHz :ON
- CH6 16804.50kHz :OFF
0.Back
To Next Page
Loading...