Operation
4-20
4
4
.
.
2
2
.
.
6
6
.
.
3
3
SFEC mode operation
Messages can be sent to the specific stations as a broadcast on the selected work frequency
using the SFEC mode. Additionally, regarding the SFEC reception, refer to the previous section
because it is similar to the CFEC reception.
■ Procedure ■
1
1
1
.
.
.
If displaying the message of "Press Enter key to get the access right in the NBDP
mode…" on the data terminal, press Enter key on the keyboard.
The operation of the data
terminal becomes possible in
the telex mode, except when
the controller is used.
2
2
2
.
.
.
On the main menu and the dropdown menu, select Connect SFEC with Enter key.
The registered station list is
displayed. (See 5.7.2 for
station list registration.)
When selecting [Manual] on
this station list, the ID and
frequency or ITU channel
can be input manually.
3
3
3
.
.
.
Select the station to be called with the cursor, and press Enter key.
The frequency list of the selected
radio station is displayed.
If the position of the station is
registered, the MUF (maximum
usable frequency) is displayed in
the lowest line as a reference to
select the frequency. Also, the
MUF can be calculated by the
menu of Service MUF
calculation.
Station selection
No. Station Name ID Location F.Sig
1 Station 01 004310123 N33ﾟ45' E138ﾟ12' DOTDOT [Select]
2 Station 02 004311234 N37ﾟ22' E135ﾟ51' DOTDOT [Manual]
3 Station 03 431012345 [Cancel]
4
5
6
7
8
9
10 ↓
1 Station 01 004310123 N33ﾟ45' E138ﾟ12' DOTDOT
[TEL] Tx= 2174.50kHz/Rx= 2174.50kHz USB
File Tune Connect Service System Help
STATUS INFO
[No scanning] TUNER :[READY]
Tx.POWER :[HIGH]
Press Enter key to get the access right in the NBDP mode...
Scanning info
Tuner/Tx.POWER
Last status message
MF
HF
To Next Page
Loading...