JRC JSS-2500 - 6.6.3 Consumables; 6.6.4 Repair units;parts; 6.6.5 Regular replacement parts

Operation
4-21
4
4
4
.
.
.
Select the work frequency with the cursor, and press Enter key.
 The selected frequency is set and the
antenna is tuned to the frequency.
 The message as shown at right is
displayed to confirm that the channel
is busy.
5
5
5
.
.
.
Select Yes and press Enter key to start the call at the selected frequency.
 The SFEC broadcasting is
started.
 First, the phasing signal same
with CFEC mode is sent.
6
6
6
.
.
.
After sending the phasing signal followed by the SELCAL number, the message
sending using the SFEC mode will be available.
The screen as shown at right
is displayed.
The following procedure is the same as the CFEC mode.
Note
[TLX] Tx= 2174.50kHz/Rx= 2174.50kHz USB
File Tune Connect Service System Help
STATUS INFO
ST-BY
[No scanning] TUNER :[READY]
Tx.POWER :[HIGH]
SFEC: 20 AUG,2010 17:15
Station:[Station 01] ID:[004310123] Loc:[N33ﾟ45'E138ﾟ12']
*Waiting for transmitter ready
*Received TX-READY signal
F10 Stop
Free sig. SFEC
Calling
Send
Phasing Repeat RQ
Scanning info
Tuner/Tx.POWER
Last status message
MF
HF
[TLX] Tx= 2174.50kHz/Rx= 2174.50kHz USB
Station ID:[004310123]
TELEX Terminal Window
ARQ
Message start...
F3 Hereis | F4 TMS | F8 F.Send | F10 Stop
Free sig. SFEC
Calling
Send
Rephasing Repeat RQ
MF
HF