JRC JSS-2500 - 6.3.1 Alert state indications; 6.3.2 BAM alert display and operation; 6.3.2.1 Alert by DSC receiving; 6.3.2.2 Alert by equipment error

Operation
4-16
4
4
.
.
2
2
.
.
6
6
.
.
2
2 CFEC mode operation
（１） Sending with CFEC
Messages can be sent as a broadcast on the selected work frequency using the CFEC mode.
■ Procedure ■
1
1
1
.
.
.
If displaying the message of "Press Enter key to get the access right in the NBDP
mode…" on the data terminal, press Enter key on the keyboard.
The operation of the data
terminal becomes possible in
the telex mode, except when
the controller is used.
2
2
2
.
.
.
On the main menu and the dropdown menu, select Connect  CFEC with Enter key.
 Input the frequency or ITU
channel on the screen as
shown at right.
 To input the frequency, press
Enter key to move the cursor to
the right.
 To input the ITU channel, select
the ITU channel button and press
Enter key to display the specific
screen as shown at right. Then
press Enter key to move the
cursor to the right.
3
3
3
.
.
.
Input the work frequency or ITU channel, and press Enter key.
 The selected frequency is set and the
antenna is tuned to the frequency.
 The message as shown at right is
displayed to confirm that the channel
is busy.