Operation
4-17
4
4
4
.
.
.
Select Yes and press Enter key to start the call at the selected frequency.
Sending the phasing signal is
started with the CFEC mode.
5
5
5
.
.
.
After sending the phasing signal for about 15 seconds, the message sending using
the CFEC mode will be available.
The screen as shown at right
is displayed.
6
6
6
.
.
.
The characters typed with the keyboard can be transmitted in sequence. And all of the
characters displayed on the screen are printed out on the printer.
Refer to the chapter 2 for the
function key.
Besides alphabets and the
figures, following signs can
be input from the keyboard.
- ? : ( ) . , ‘ = / +
Note: Only the capital letter
can be used for the
alphabet.
[TLX] Tx= 2174.50kHz/Rx= 2174.50kHz USB
File Tune Connect Service System Help
STATUS INFO
ST-BY
[No scanning] TUNER :[READY]
Tx.POWER :[HIGH]
CFEC: 20 AUG,2010 17:15
*Waiting for transmitter ready
*Received TX-READY signal
F10 Stop
Free sig. CFEC
Calling
Send
Phasing Repeat RQ
Scanning info
Tuner/Tx.POWER
Last status message
MF
HF
[TLX] Tx= 2174.50kHz/Rx= 2174.50kHz USB
TELEX Terminal Window
ARQ
Message start...
F3 Hereis | F4 TMS | F8 F.Send | F10 Stop
Free sig. CFEC
Calling
Send
Rephasing Repeat RQ
MF
HF
[TLX] Tx= 2174.50kHz/Rx= 2174.50kHz USB
TELEX Terminal Window
ARQ
Message start...
THE QUICK BROWN FOX JUMPS OVER THE LAZY DOG 1234567890.
THE QUICK BROWN FOX JUMPS OVER THE LAZY DOG 1234567890.
THE QUICK BROWN FOX JUMPS OVER THE LAZY DOG 1234567890.
THE QUICK BROWN FOX JUMPS OVER THE LAZY DOG 1234567890.
END OF TEST
F3 Hereis | F4 TMS | F8 F.Send | F10 Stop
Free sig. CFEC
Calling
Send
Rephasing Repeat Traf
MF
HF
To Next Page
Loading...