Operation
4-12
4.2.5 Receiving AM broadcasts
It is possible to listen to the radio in AM mode.
■ Procedure ■
1
1
1
.
.
.
When operating on a controller without
access rights (OCC is displayed), press the
jog dial to obtain the access rights.
Unless the controller with access rights is
being used, the access rights are acquired
and the OCC display on the screen
disappears.
2
2
2
.
.
.
Press the MENU key, and through
hierarchical menus, select 5. Radio
operation.
3
3
3
.
.
.
Move the cursor to 3. Mode, and press
ENT.
Move the cursor to the right as shown in the
figure at right to select a communication mode.
4
4
4
.
.
.
Turn the jog dial to select AM, and press
ENT.
The communication mode is set to AM and the
previous frequency (or the default frequency at
just after turning on) is set.
5
5
5
.
.
.
Press the MENU key twice to return to the
status display and if required, input an AM
broadcast frequency using the numeric keys.
Then press ENT to receive the broadcast.
- Adjust the reception level and
volume by turning the VOL and RF
GAIN knobs according to the
reception conditions.
- The AM mode is for reception only so a
transmission frequency is not shown.
Additionally, if AM is selected during
blinking “T” (ATU does not tuned), the
condition remains even after changing
to the AM mode.
ID 431001234 23:59(UTC)
Pos 89ﾟ59.0123'N
179ﾟ59.6789'E@23:59
TEL Rx: 594.00/Tx:-----.--kHz
5)Radio operation
1.User channel list
2.ITU channel list
3.Mode :AM
4.Receiver
5.Transmitter
6.ITU CH of RR2012 :Apply
0.Back
GPS
ID 431001234 23:59(UTC)
Pos 89ﾟ59.0123'N
179ﾟ59.6789'E@23:59
TEL Rx:13077.00/Tx:12230.00kHz
5)Radio operation
1.User channel list
2.ITU channel list
3.Mode :TEL
4.Receiver
5.Transmitter
6.ITU CH of RR2012 :Apply
0.Back
TEL
G
PS
ID 431001234 23:59(UTC)
Pos 89ﾟ59.0123'N
179ﾟ59.6789'E@23:59
TEL Rx:13077.00/Tx:12230.00kHz
5)Radio operation
1.User channel list
2.ITU channel list
3.Mode :TEL
4.Receiver
5.Transmitter
6.ITU CH of RR2012 :Apply
0.Back
1.User channel list
GPS
Note
To Next Page
Loading...