JRC JSS-2500 - Set the Channel to Use in the Telex Mode

Settings & Registrations
5-24
5.9 Set the channel to use in the telex mode
HF radio equipment capable of operating NBDP should be updated to have seven digits frequency
resolution to the hundredth place when using the unit of kHz to meet new channeling
arrangement of amended Appendix 17 of the 2012 Radio Regulations after January 2017. In order
to correspond to the channel after 2017, change the telex channel setting by the following
procedure.
■ Procedure ■
1
1
1
.
.
.
Press the MENU key, and through
hierarchical menus, select 5. Radio
operation.
2
2
2
.
.
.
Move the cursor to 6. ITU CH of RR2012,
and press ENT.
Move the cursor to the right as shown in the
figure at right to select a communication
mode.
3
3
3
.
.
.
Select the digit with the jog dial, and press
ENT.
Apply:
 Telex channel is set to new channeling arrangement of amended Appendix 17 by the first
radio survey after January 2017.
Not apply:
 Telex channel is set to old channeling arrangement of amended Appendix 17 by the first
radio survey before January 2017.
・ See chapter 11 Appendix (4), (5) for telex channel details.
See 5.3.8 for frequency display setting.
ID 431001234 23:59(UTC)
Pos 89ﾟ59.0123'N
179ﾟ59.6789'E@23:59
TEL Rx:13077.00/Tx:12230.00kHz
5)Radio operation
1.User channel list
2.ITU channel list
3.Mode :TEL
4.Receiver
5.Transmitter
6.ITU CH of RR2012 :Apply
0.Back
Apply
G PS
Note