Settings & Registrations
5-12
5
5
5
.
.
.
After completing the above steps, the
cursor returns to Type.
If necessary, change the group attribute
(communication mode or custom).
The following attributes can be
selected:
TEL ꞏꞏꞏꞏꞏꞏꞏꞏꞏ Radiotelephone mode
DSC ꞏꞏꞏꞏꞏꞏꞏꞏꞏ Digital selective calling mode
CW ꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏ Continuous wave mode
Custom Communication mode mix
6
6
6
.
.
.
When setting of group attributes is
completed, the cursor returns to the
topmost row of the channel number.
(CHNo).
7
7
7
.
.
.
Select the channel number to register
with the jog dial, and press ENT.
Register as follows in the popup screen at right.
When the group attribute is Custom, specify
the communication mode at Mode.
Otherwise, the communication mode is
fixed to the mode specified at Type.
To reference a frequency from the ITU
channel, move the cursor to ITU channel,
press ENT, and specify that channel
number.
Move the cursor to Rx freq(kHz), press
ENT, and enter the Rx frequency.
Move the cursor to Tx freq(kHz), press
ENT, and enter the Tx frequency.
8
8
8
.
.
.
After completing the above steps, move
the cursor to OK, and press ENT to
complete registration.
Follow the same procedure above to
create a group of channels.
Already registered channels can be
changed by the above procedure.
To close this menu, place the cursor on
any one of the registration numbers, and
press the CANCEL key.
- To delete an already registered channel, move the cursor to Erase in the above
popup screen, and press ENT.
- To erase an already registered group, move the cursor to "000 ALL CLEAR
function" in the bottommost row of the channel list, and press ENT. Next,
move the cursor to OK in the confirmation screen, and press ENT.
- To erase all already registered groups, move the cursor to "00 ALL CLEAR
function" in the User channels (index) screen, and press ENT. Next, move the
cursor to OK in the confirmation screen, and press ENT.
- When the 7.6.1 Connection is set to DTE, the group 20 becomes the reserved
group for telex channels of the data terminal and inaccessible at the controller.
Note
7.4)User channels (table)
Name: Japan Radio
Type: TEL
CHNo Rx[kHz] Tx[kHz] Mode
041
042
043
044
045
046
7.4)User channels (table)
Name: Japan Radio
Type: TEL
CHNo Rx[kHz] Tx[kHz] Mode
041
042
043
044
045
046
7.4)User channels (table)
Name: Japan Radio
Type: TEL
CHNo Rx[kHz] Tx[kHz] Mode
041
042
043
044
045
046
4071.00 4071.00 TEL
7.4)User channels (table)
Name: Japan Radio
Type: TEL
CHNo Rx[kHz] Tx[kHz] Mode
041
042
043
044
045
046
CHNo. 041/Type TEL
Mode :TEL
ITU Channel :
Rx freq(kHz) : .
Tx freq(kHz) : .
[OK] [Cancel] [Erase]
To Next Page
Loading...