Operation
4-9
6
6
6
.
.
.
Press the key to tune the antenna.
- T blinks if the transmission frequency
is not tuned.
- Even if T is not displayed, tune the
antenna before making a call.
- T lights during tuning. It goes out
after tuning.
7
7
7
.
.
.
Lift the handset from the cradle.
8
8
8
.
.
.
Press the PTT key to talk.
The TX and ON marks appear on the screen to
show the equipment is transmitting. Releasing the
PTT key returns it to receiving.
Pressing the PTT key turns on the power
to the PA automatically.
9
9
9
.
.
.
When finished communicating, return the
handset to the cradle.
■ Making a radiotelephone call ■
1
1
1
.
.
.
Set a frequency the station to be called is monitoring.
2
2
2
.
.
.
Lift the handset from the cradle.
3
3
3
.
.
.
Press the PTT key, check that TX and ON are displayed and make a call as described
below.
Say the name of the station being called ... Repeat 3 times.
Say "This is..."
Say own ship name ... Repeat 3 times.
If necessary, indicate your working frequency.
"over"
4
4
4
.
.
.
Release the PTT key to listen.
5
5
5
.
.
.
Start communicating according to the response. When changing frequencies, make
sure that no other stations are using the indicated working channel.
- When transmitting from your own station, always press the PTT key while talking.
- On a simplex channel, always say "over" just before releasing the PTT key.
- Always say "out" when terminating communications.
CW
ITU- 402
ON
ID 431001234 23:59(UTC)
Pos 89ﾟ59.0123'N
179ﾟ59.6789'E@23:59
P
WR
12 -S N2
D
UP
W
KR
2
4
6
8
12
16
A COMM
Communicating on
CW Rx: 4360.00/Tx: 4068.00kHz
Tip)Use FUNC to change op area.
[HLD][END]
T
RX
4360.00
kHz
TX
4068.00
kHz
GPS
Note
ANT
TUNE
Note
Note
To Next Page
Loading...