Options Operation 
10-12 
The following shows the functions of the operation panel.   
 
 
 
 
 
 
 On Line  ꞏꞏꞏꞏꞏꞏ   When the On Line lamp is lit, the printer is ready for printing. 
And the following operation is available in this condition. 
- Preview  : Feeds the paper some lines temporally to 
show the printed lines hidden under the cover. 
To undo it, repress this key. Also, cannot 
print during preview. 
 Off Line  ꞏꞏꞏꞏꞏꞏ   Sets the printer to the offline state if pressing during the online 
state. During the offline state, the On Line lamp is turned off and 
the following operations become available. To undo it, repress 
this key. 
-  Tear Off  :  Inserts line feeds to cut the paper at the end 
of the printed line.   
-  LF/FF  :  Feeds the paper one line if pressing a moment 
or feeds the paper one page if holding down a 
few seconds.   
-  Eject  :  Reverses the paper back out to eject it.   
Moreover, to set the printer to the adjustment mode and change 
the following conditions, hold down the Off Line key for three 
seconds. To undo it, repress this key for a moment. 
-  Mode  :  Selects the Mode1 or Mode2. 
Note)  Always set to the Mode1. Additionally, 
the Custom is not accessible.   
- Micro Adjust : Fine-tunes the feed length of the Preview.   
 
-  When the paper runs low, the Paper Out lamp starts blinking with beeping. 
-  When the printer runs out of roll paper, the Paper Out lamp lights and the printer 
automatically goes offline in the same way as the friction lever pulled to the front.   
-  When pressing the Eject key in the offline state, the Paper Out lamp lights even 
though still remains the roll paper. In this case, the friction lever or the power 
switch operation can recover the condition, but to avoid troubles such a paper 
jam, basically remove the roll paper from the printer.   
-  Do not cut off the paper just after feeding lines by pressing the Preview key. Always use the 
Tear Off key when feeding lines to cut off the paper. 
 
■ Loading the printer paper ■ 
1
1
1
.
.
.
 
 
 
Turn the printer OFF, open the printer cover 
and remove the roll paper cover.   
At this step, pull the friction lever towards the 
front. 
 
 
 
Note 
Roll paper cover 
Printer cover 
Friction lever