Operation
4-27
(2) Setting the ITU channels
■ Procedure ■
1
1
1
.
.
.
After setting the TEL, DSC or CW modes,
press the CH key to set the display to the
ITU channel mode.
2
2
2
.
.
.
Input the channel by using the numeric
keypad.
When 4 is input using the numeric
keypad, it appears on the far right
as shown in the screen on the right.
3
3
3
.
.
.
Input the rest of the digits and press ENT.
The input ITU channel frequency is displayed
and the settings are complete.
- See the appendix "11.4 ITU channel list (TEL/CW/TLX)" for a list of
pre-installed ITU channels and their frequencies.
- Besides doing settings with the numeric keypad, settings can also be done with
the jog dial.
- For DSC mode, normally perform the above procedure to receive the routine
message. Furthermore, when sending a DSC message, the calling frequency is
set via the menu automatically and the above procedure is not needed.
- The above operation is unavailable in the telex mode. The ITU channel in the
telex mode is set with the controller menu 5.2 ITU channel list, or the data
terminal menu operation, as Tune ITU channel set.
TEL
ITU- 401
ID 431001234 23:59(UTC)
Pos 89ﾟ59.0123'N
179ﾟ59.6789'E@23:59
SIG
12 -S N2
RX
4357.00
kHz
TX
4065.00
kHz
WKR 2 4 6 8 12 16
A COMM
Communicating on
TEL Rx: 4357.00/Tx: 4065.00kHz
Tip)Use FUNC to change op area.
[HLD][END]
D
UP
G
PS
TEL
ITU- 4
ID 431001234 23:59(UTC)
Pos 89ﾟ59.0123'N
179ﾟ59.6789'E@23:59
S
IG
12 -S N2
RX
4360.00
kHz
TX
4068.00
kHz
W
KR
2
4
6
8
12
16
A COMM
Communicating on
TEL Rx: 4360.00/Tx: 4068.00kHz
Tip)Use FUNC to change op area.
[HLD][END]
D
UP
G
PS
TEL
ITU- 402
ID 431001234 23:59(UTC)
Pos 89ﾟ59.0123'N
179ﾟ59.6789'E@23:59
S
IG
12 -S N2
RX
4360.00
kHz
TX
4068.00
kHz
W
KR
2
4
6
8
12
16
A COMM
Communicating on
TEL Rx: 4360.00/Tx: 4068.00kHz
Tip)Use FUNC to change op area.
[HLD][END]
DUP
G
PS
Note
Note
To Next Page
Loading...