21
Brake Endpoint Adjustment
BRG (Grip Lever A Throttle
Travel Adjust)
The brake endpoint adjustment, located at grip lever A,
allows the maximum servo travel on the braking side of the
throttle trigger to be increased or decreased from 100% to
0% (off). This function is very useful in race conditions as it
allows the racer to custom tailor the “panic” brake value to
maximize the cars braking power for the current track condi-
tions. Please note that since the brake endpoint value shown
in the BRG screen is a percentage of the total braking value
established in the Travel Adjust function (page 14), the value
will not always increase or decrease, or beep once for each
time the grip knob A is moved.
To adjust the brake endpoint value, move the electronic grip
lever A either left (–) or right (+). As soon as the grip lever is
moved, the BRG Travel Adjust screen will appear, and will
continue to be displayed unless the grip lever A is untouched
for a period of five seconds. To reset the brake endpoint
value to the factory preset 50% setting, press the INCREASE
and DECREASE keys at the same time while the BRG screen
is displayed.
Current value
INCREASE
CLEAR
+–
DECREASE
To Next Page
Loading...
Need help?
General
