Need help?Do you have a question about the JRRacing XS3 and is the answer not in the manual?
General| Brand | JRRacing |
|---|---|
| Model | XS3 |
| Category | Remote Control |
| Language | English |
Configure transmitter channel for desired frequency band and channel number.
Set receiver channel to match transmitter using rotary switches.
Adjust servo direction for steering, throttle, and auxiliary channels.
Adjust the maximum travel of steering, throttle, and auxiliary channels.
Adjust the center position of the steering servo using the trim lever.
Adjust the center position of the throttle servo using the trim lever.
Adjust brake trim using Grip Lever A.
Lists the capabilities and functions of the XS3 transmitter.
Lists the capabilities and features of the RS300 receiver.
Lists the features of Z270 and Z590M servos.
Technical details of the XS3 transmitter like RF output, power source.
Technical details of the RS300 receiver like sensitivity, power supply.
Technical details for Z270 and Z590M servos.
Identifies and locates all buttons, levers, and displays on the transmitter.
Instructions for accessing and installing batteries in the transmitter.
Important safety warnings for operating RC models.
Warning about the impact of low transmitter/receiver voltage on performance.
How to adjust the tightness of the steering wheel.
Details on the transmitter's charging jack and required charger.
How the receiver gets power and voltage considerations for BEC systems.
Connecting a mechanical speed controller to the BEC receiver.
Connecting an electronic speed controller to the receiver.
Proper methods for mounting the receiver and routing the antenna wire.
Correct sequence for turning the radio system on and off.
Diagram and notes on how to mount servos using grommets and eyelets.
How to access System mode using button combinations.
How to access Function mode using the Scroll key.
How to clear the screen or return to factory presets.
Description of the default screen showing channel and battery voltage.
Indicates low battery warnings and the role of the lithium backup.
How to display and use the up-timer feature and memory error screens.
Instructions on how to enter and exit the transmitter's System mode.
How to select one of the six available models for operation.
How to select a transmission channel without crystals.
How to input a three-character name for each model.
How to choose between Normal (N) and Fast (F) frame rates.
Options for Channel 3: Inhibit, Linear, or 2-Position.
Assigns functions like Lap-Timer or Emergency Steering to Grip Button C.
Resets selected model programming to factory defaults.
Copies settings from one model to another.
How to enter and navigate the transmitter's Function mode.
Adjusts neutral throttle area for better control.
Alters steering/throttle response rate around neutral.
Adjusts maximum servo travel in each direction.
Allows mixing of one channel's input to another channel.
Records individual lap times.
Adjusts servo neutral position electronically.
Changes the direction of servo operation.
Adjusts the center position of the steering servo.
Adjusts the center position of the throttle servo.
Adjusts brake travel using Grip Lever A.
Trim adjustment for Auxiliary Channel 3 (LN mode).
How to use the steering trim lever to center the servo.
How to use the throttle trim lever to center the servo.
Tailors steering sensitivity and radius using Grip Lever B.
Adjusts brake travel from 100% to 0% using Grip Lever A.
Uses Grip Lever A for fuel mixture adjustment (LN mode).
Uses Grip Lever A for gear shifting (2P mode).
Data sheet section for System Mode parameters.
Data sheet section for Function Mode parameters.
Data sheet section for Direct Mode parameters.
Lists frequencies and corresponding channels for 27MHz band.
Lists frequencies and corresponding channels for 75MHz band.
Details the warranty period and what is covered.
Instructions for sending the system for repair.
Information on non-warranty service and estimates.
To Next Page
