22
Function Mode
Exponential Function
The Exponential feature of the XS3 allows you to alter the
response rate of the steering or throttle control around neu-
tral without affecting the maximum amount of steering or
throttle available. The adjustment range is from -100% to
0% (Linear) to +100%. Exponential is factory set to linear
for both steering and throttle. Exponential is often used to
settle down a car that is twitchy around center without giv-
ing up maximum steering response. The XS3 provides both
positive (increase sensitivity at neutral) and negative
(decrease sensitivity at neutral) exponential values.
Accessing the Exponential Function
1.Turn the transmitter power switch on.
2.Press the Scroll key to access the Function mode.
3.Press the Scroll key until “EXP” appears in small letters
on the left side of the screen.
4.Press the Increase or Decrease keys to select the desired
exponential value.
5.Press the Scroll key to access the travel End-Point
Adjustment function.
6.To exit the Function mode, either turn off the transmitter
power switch or press the Scroll and Channel keys at the
same time.
st
ln
EXP
Steering Exponential
Adjustment
Current Value
thf
ln
EXP
Forward Throttle Exponential
Adjustment
Current Value
thb
ln
EXP
Braking Exponential
Adjustment
Current Value
Press the Scroll key until "EXP" appears on the
screen.
Press the Increase and Decrease keys to select the
desired exponential value. Values: -100% to Linear
(LN) to +100%.
SCROLL
ENTER
CHANNEL
INCREASE
CLEAR
DECREASE
To Next Page
Loading...
