Receiver/ Servo Connections and Installation
Operating Your Model
It’s important to learn the proper sequence for switching
on/off your radio system.
Before Operation
Switch on the transmitter, then the receiver.
After Operation
Switch off the receiver, then the transmitter. This ensures
that you will always have a signal to the receiver and that
your RC model will not operate out of control when you
turn off the transmitter.
10
Your RS300 needs to be mounted so the receiver is isolated
and floats to avoid damage from shock or vibration.
Placement of the RS300’s case should not come in direct
contact with hard or rigid surfaces.
1.Mount the RS300 receiver with double-sided tape. (Use
extra layers of double-sided tape, particularly if it is thin,
until you build up a cushioning pillow layer.)
Do not use glue to mount the receiver!
2.Run the antenna wire up through a plastic antenna tube
and let the excess wire hang out the top of the tube.
3.Do not cut, coil, or bundle excess antenna wire—range
will be reduced!
To Next Page
Loading...
