24
Function Mode
Accessing The End-Point
Adjustment Function
1.Turn on the transmitter power switch.
2.Press the Scroll key to enter Function mode.
3.Press the Scroll key until “EPA” appears in small letters
on the left side of the screen.
4.Press the Channel key to select the desired channel to be
adjusted.
Steering = ST R/B(steering right) or ST L/F (steering left)
Throttle = TH L/F (forward) or TH R/B
(braking or reverse)
Auxiliary Channel 3 (optional) = AUX L/F or AUX R/B
(function 2P only)
Press the Scroll key until "EPA" appears on the
screen. Press the Channel key to select the channel
to be adjusted.
Move the wheel, trigger or Grip Button C in the
desired direction and press either the Increase or
Decrease keys to achieve the desired travel value.
SCROLL
ENTER
CHANNEL
INCREASE
CLEAR
DECREASE
5.Move the steering wheel, trigger or Grip Button C in the
desired direction for adjustment (left/right, forward/
reverse or brake). Press the Increase or Decrease key
to achieve the desired amount of travel. Move the
wheel, trigger or Grip Button C in the opposite direction
to adjust the travel in the opposite direction.
Note: For Auxiliary Channel 3 function, if LN is
selected, only L/F is adjustable.
6.Press the Scroll key to access the Mixing Adjustment
function.
7.To exit the Function mode, either turn off the transmitter
power switch or press the Scroll and Channel keys at the
same time.
Note: When setting the end point adjustment
values for the steering function, it is suggested that,
if possible, the maximum travel values be set to an
equal value in both directions to maintain proper
steering control.
To Next Page
Loading...
