26
Function Mode
Lap-Timer
The Lap-Timer function of the XS3 allows the recording
of individual lap times based on a 999 second up-timer.
Up to 50 laps and times from 3.0 to 99.9 seconds can be
stored in memory for review at a later time. The Lap-Timer
function will only be enabled and shown in Function mode
if Grip Button C (System Mode) is set to “LA.” With the
Lap-Timer enabled, pressing the channel key will alternate
between the Normal display screen and Up-Timer display
screen.
The Lap-Timer is started by pressing Grip Button C. Once
active, as shown by the blinking word “LAP,” pressing Grip
Button C again will begin recording the time of the next lap.
Note: A 3.0 second lap is the quickest lap allowed.
This prevents accidental double pushing of Grip
Button C when recording lap times. If more than
50 laps are recorded, each new lap will overwrite
the oldest lap held in memory.)
To stop the Lap-Timer, press the Increase and Decrease
keys at the same time. To restart the Lap-Timer, press Grip
Button C. To reset the Up-Timer, press the Channel key to
show the Up-Timer display screen. With the Up-Timer
stopped, press the Increase and Decrease keys at the same
time to reset.
To review or reset lap times you must be in the Lap-Timer
function mode screen. Upon entering this function, the
screen will always show the last lap time recorded. Use the
Increase or Decrease keys to view the desired lap(s).
Note: If a recorded lap time is greater than 99.9
seconds, “OVR” will be displayed.)
To reset all lap times, press the Increase and Decrease keys
at the same time.
401
20
LAP
Recorded Lap
Time to 1/10th of
a second
(i.e. 40.1 sec.)
Current
Lap Number
—
A minus sign indicates a pre-existing lap. Current lap times have no sign.
Accessing The Lap-Timer Function
1.Turn on the transmitter power switch.
2.Press the Scroll key to enter Function mode.
3.Press the Scroll key until “LAP” appears in the screen.
4.Press the Increase or Decrease keys to view the desired
lap time(s).
5.To reset all lap times press the Increase and Decrease
keys at the same time.
6.Press the Scroll key to access the Sub-Trim function.
7.To exit the Function mode, either turn off the transmitter
power switch or press the Scroll and Channel keys at the
same time.
Press the Scroll key until "LAP" appears on the
screen.
Press the Increase or Decrease keys to view the
desired lap time(s).
SCROLL
ENTER
CHANNEL
INCREASE
CLEAR
DECREASE
To Next Page
Loading...
