9. How to set the machine head and to initialize data
(the factory-set state at the time of shipment)
A
– 41 –
1) Turn the power ON while keeping
or
, or
and
held pressed
simultaneously. (This function is activated under
the service level.)
2) Press
to
to select the function
setting No. 70 (
A
).
3) Conrm the data with
.
4) Press
and
to select the corre-
sponding machine head.
Set value = 2: DDL-7000AS-7
Set value = 3: DDL-7000AH-7
3) Data is initialized by pressing
. Then, the sewing machine returns to the normal sewing state.
* If you want to initialize the data, change the setting of the type of machine head to a dierent type, then
select the desired type of machine head.
Example) In the case the selected type of machine head is "2":
P70 Change the selected type of machine head from "2" to "3". Press
.
Change the selected type of machine head again from "3" to "2". Press
.
To Next Page
Loading...
Need help?
General
