ā 35 ā
Input function list
Function
code
Abbrev
ia-
t
ion
Function item
Remarks
0 noP No funct
ion (Standard setting)
1 HS N
eedle up / down compensating
stitching
Every time the switch is pressed, normal feed stitching
by half stitch is performed. (Same operation as that of up
/ down compensating stitching switch on the panel.)
2 bHS Back compensat
ing stitching
Reverse feed stitching is performed at low speed while the
switch is held pressing.
3 EbT Function of canceling once re-
verse feed stitching at the end of
sewing
By depressing the back part of the pedal after pressing
the switch, operation of reverse feed stitching is can
-
celed once.
4 TSW Thread tr
imming function This function is actuated as the thread trimming switch.
5 FL Presser foot l
ifting function This function is actuated as the foot lifter switch.
6 oHS One st
itch compensating stitching Every time the switch is pressed, one stitch stitching op-
eration is executed.
7 SEbT Funct
ion of cancel of reverse feed
stitching at start/end
By operating the optional switch, ineffective/effective can
be alternately changed over.
8 PnFL P
resser lifting function when pedal
is neutral
Every time the switch is pressed, the function whether
automatically lifting the presser foot when the pedal is
neutral or not can be selected.
9 Ed Mater
ial edge sensor input
This function works as the input signal of material edge sensor.
10 LinH Function of prohibiting depressing
front part of pedal
Rotat
ion by pedal is prohibited.
11 Ti
nH Function of prohibiting thread
trimming output
Output of thread trimming is prohibited.
12 LSSW Low speed command
input This function works as low speed switch for standing
sewing machine.
13 HSSW H
igh speed command input This function works as high speed switch for standing
sewing machine.
14 USW Needle l
ifting function UP stop motion is performed when switch is pressed dur-
ing DOWN stop.
15 bT R
everse feed stitching switch in-
put
Reverse feed stitching is output as long as the switch is
held pressed.
16 SoFT Soft start sw
itch input The speed of stitch is limited to the predetermined soft-
start speed as long as the switch is held pressed.
17
oSSW
One-shot
speed command switch
input
This function works as one-shot speed command as long
as the switch is pressed.
18
bKoS
Backward one-shot speed com-
mand sw
itch input
Reverse feed stitching is performed in accordance with
the one-shot speed command as long as the switch is
held pressed.
1
9
SFSW
Safety sw
itch input Rotation is prohibited.
20
MES
Thread
trimming safety switch in-
put
I
t operates as an input signal of the thread trimmer safety
switch.
21
AUbT
A
utomatic reverse feed stitching
cancellation/addition switch
Every time the switch is pressed, reverse feed stitching
at sewing start or reverse feed stitching at sewing end is
cancelled or added.
22
CUnT
Sewing counter input
Every time the switch is pressed, the sewing counter
value is increased.
23 Tii
n Tsw command prohibition input Thread trimming command is prohibited.
24 USTP Lsw
command prohibition/needle-
up stop input
Sewing by means of the pedal switch is prohibited.
The sewing machine stops with its needle up during
sewing.
To Next Page
Loading...
