EasyManua.ls Logo

JUKI HZL-F series - Adjusting the thread tension release adjusting plate; Pretension disk opening amount

JUKI HZL-F series
133 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Walking foot
N
In general, this presser foot is used for difficult-to-feed” materials such as knits,
jersies, vinyl, articial leather and leather or quilting.
Patchwork presser
foot
P
This presser foot is used for patchwork stitches. There are two seam lines, 1/4-inch
and 1/8-inch from center needle position.
Smooth presser foot
T
This presser foot is used for non-slippery materials like vinyl and satin stitches.
Open toe presser foot
O
This is used for the applique and decorative stitches. (Front part of the presser foot
is open for better visibility).
Quilt presser foot
Q
This is used for the quilt stitch.
(Machine setting: Straight Stitch and Center needle position).
Edge Sewing presser
foot
R
This is used for patchwork, sewing center line of joined materials by using the
center guide of the presser foot.
* Fine tune the needle position by zigzag width adjustment dial.
18
F600 / F400
F600 / F400
F600 / F400
Marking of presser foot
F600
F600
F600

Table of Contents

Other manuals for JUKI HZL-F series

Related product manuals