53
2. If the stitches fail to reach the folded edge
1. If the stitches reach too far beyond the folded edge
F400 / F300
Push the zigzag width adjusting button "-".
F600
Turn the zigzag width adjusting dial to the left side.
When changing the needle entry point
Turn the handwheel to check the
needle entry point. When adjusting,
make sure the needle is in the up
position.
F600
Turn the zigzag width adjusting dial to the right side.
F400 / F300
Push the zigzag width adjusting button "+".
Turn the handwheel to check the
needle entry point. When adjusting,
make sure the needle is in the up
position.
To Next Page
Loading...
