JUKI KE-2000 Series - Connecting Matrix Tray Changer (MTC); MTC Interface Panel Connection

KE2000 Installation Manual
39
14. Connecting the matrix tray changer (MTC)
14-1. Interface panel
Connect the MTC power connector and signal connector to the interface panel on the
right side of the main unit. Additionally, connect the air tube to the MTC air joint on the
rear of the main unit. (In case of an MTS, connect it on the left side of the main unit.)
<CAUTION>
Always use the cables and air tubes supplied with the MTC.
Fig 14-1-1 Right side view of the main unit
MTC si
g
nal connector
MTC
p
ower connector