JUKI LK-1900B series - Page 31


28

No. Item name Pictograph Input range Remarks:
S001
Type of pattern
/
Standard pattern /
User pattern
* This data is for display only. To edit
the data, delete the direct pattern
and create a new direct pattern.
S002
Pattern No.
Standard pattern
:
1 to 51
User pattern
:
1 to 200
* This data is for display only. To edit
the data, delete the direct pattern
and create a new direct pattern.
S003
X enlargement/
reduction scale/
actual dimension
When inputting in terms of per-
centage (%): 20 - 200 %
When inputting an actual dimen-
sion: Within the range of actual
dimensions corresponding to the
percentage
Input method (percentage or actual
dimension) can be selected by setting
the memory switch U064. (Initial val-
ue: Input in percentage)
S004
Y enlargement/
reduction scale/
actual dimension
When inputting in terms of per-
centage (%): 20 - 200 %
When inputting an actual dimen-
sion: Within the range of actual
dimensions corresponding to the
percentage
Input method (percentage or actual
dimension) can be selected by setting
the memory switch U064. (Initial val-
ue: Input in percentage)
S005
Thread tension
0 to 200 Directly specify the thread tension
with the THREAD TENSION key.
The thread tension cannot be select-
ed with
▼▲
key.
S006
Sewing speed
400 to 3200 The maximum input range depends
on the maximum sewing speed set
with the memory switch U001.
S007
X travel amount
− 20 to 20
S008
Y travel amount
− 20 to 10
S009
2-step stroke
work clamp
stroke height
50 to 90 Display/hide of the stroke height can
be selected using the memory switch
U069. (Initial value: Hide) When the
hide is selected, the stroke height is
not displayed on the data edit screen.
S010
Position of the
last stitch X trav-
el amount
− 2.0 to 2.0 Display/hide of the stroke height can
be selected using the memory switch
U070. (Initial value: Hide) When the
hide is selected, the stroke height is
not displayed on the data edit screen.
S011
Position of the
last stitch Y trav-
el amount
− 2.0 to 2.0 Display/hide of the stroke height can
be selected using the memory switch
U070. (Initial value: Hide) When the
hide is selected, the stroke height is
not displayed on the data edit screen.
S012
Comment
The number of characters that can
be input: 14
(2) Listing of item data