－
91
－
2-2. Installing the regulator and solenoid valve asm.
Mount the solenoid valve asm. and regulator asm. on the undersurface of the table respectively with two set-
screws
and two setscrews
.
Mount the solenoid valve asm., near cord through-hole
(see the gure) in and regulator asm. on the far left
section of the undersurface of the table as observed from the worker.
2-3. Installing the air hose
* Air hose piping
Connect air hose
to regulator
.
* Adjusting the pneumatic pressure
Pull up air regulating knob
of the regulator.
Then, turn the knob to adjust the pneumatic
pressure at 0.5 MPa. Push down the knob to its
home position to x it.
To Next Page
Loading...
