31
(2) Method of editing cycle data
1) Set the mode to input mode.
Under the input mode where SET READY LED
goes out, entry of the cycle data is enabled.
If the current mode is the sewing mode, press
READY key
to change over the mode
to the input mode.
2) Set cycle data to editing status.
When EDIT key
is pressed, the cycle
data editing display
C
appears on the screen.
The pattern No.
D
to be sewn is displayed in re-
verse video.
In this state, it is possible to edit the data.
4) Change data of selected editing point.
Press DATA CHANGE key
and data of editing point can be changed.
Pattern No. which has been registered is displayed and it is possible to select.
In addition, press RESET key
, and the pattern data of editing point can be deleted.
When RESET key
is held pressed for one second, all the registered pattern data can be delet-
ed.
Repeat steps
3)
and
4)
to perform editing data.
5) Cancelling insertion of pattern data
Insertion of the pattern data is cancelled and the mode is changed over to the input mode by pressing
RETURN key
.
C D
3) Selecting the edit point
When you press ITEM SELECT key
, the edit point is changed and the current point is displayed
in reverse video. When you move the edit point forward until the last point is reached, additional indica-
tion pictograph is displayed.
When you press EDIT key
while selecting the edit point, the additional indication pictograph
is displayed at the selected position to enable insertion of pattern data.
To Next Page
Loading...
