– 112 –
No. Item Setting range Unit
U182
Sewing counter stopping function
0: The sewing machine does not stop even when the sewing counter completes
counting.
1: When the counter completes counting, the sewing machine start after thread
trimming is prohibited.
* Note that the prohibition function is disabled in the case the initial value of count-
er is 0 (zero).
In addition, the prohibition function is also disabled when the pitch time is selected.
0 to 1
ー
U183
Number of times of thread trimming for sewing counter
1 to 20
ー
U194
Thread tension changeover setting when lifting the presser foot
0: OFF / 1: Normally ON / 2: Only after thread trimming / 3: Only during the imme-
diate stop
0 to 3
ー
U195
Thread tension when lifting the presser foot (right)
0 to 200
ー
U199
Pedal giving priority to sewing machine for standing work
The switch which is given priority when the pedal is used for sewing machine for
standing work is set.
0: Start switch is given priority / 1: Start switch is not given priority
0 to 1
ー
U201
Bobbin thread remaining amount to start the tension correction (bobbin
thread remaining amount)
The bobbin thread remaining amount to start the tension correction is set.
0 to 100 %
U202
Final tension correction amount (bobbin thread remaining amount)
The tension correction amount for the case the bobbin thread remaining amount is
minimized is set.
50 to 200 %
U210
Max. zigzag width limiting method
Method to set the maximum zigzag width limit
1: Center / 2: Right and left
1 to 2
ー
U211
Max. zigzag width limit value (center)
The maximum zigzag width limit value in the case the method to set the maximum
zigzag width limit is set to "Center"
0 to 100
ー
U212
Max. zigzag width limit value (right)
The maximum zigzag width limit value (right side) in the case the method to set the
maximum zigzag width limit is set to "Right and left"
0 to 50
ー
U213
Max. zigzag width limit value (left)
The maximum zigzag width limit value (left side) in the case the method to set the
maximum zigzag width limit is set to "Right and left"
-50 to 0
ー
U214
Stitch baseline reference position
The reference position of the stitch baseline is set.
0: Left / 1: Center / 2: Right
0 to 2
ー
U273
Start enable/disable setting when lifting the presser foot
Enable/disable of input for starting the sewing machine after lowering the presser
foot which is placed in its upper position is changed over.
0: Enable / 1: Disable
0 to 1
ー
U318
Correction of position to start the reverse feed lever operation
The position at which the reverse feed lever operation is enabled is set.
-40 to 40
ー
U319
Correction of position at which the reverse feed lever operating amount is
maximized
The position at which the reverse feed lever operating amount is maximized is
adjusted.
-40 to 40
ー
To Next Page
Loading...
Need help?
General
