– 5 –
(3) Example of application
1) When the CP-160 is used together with the material end sensor (ED : optional), it can be used as a small
edge-controller.
(Method) Adjust the position to mark of the CP-160, turn ON material end sensor ON/OFF switch of the
CP-160, and turn ON mark of the automatic one-shot stitching.
(Caution) 1. Number of rotations of the automatic one-shot stitching can be changed by the function
setting (No. 38).
2. It is necessary to set the material end sensor input of the function code : 9 to the input port by
using the function of the optional input/output function selection (Function setting No. 12).
Label
CD
CD
2) Label attaching is performed by the automatic one-shot stitching with the CP-160
(Method) Select mark on the CP-160, and turn ON mark of the automatic one-shot stitching.
(Explanation) Number of stitches at the section CD can be set up to 500 stitches. If the stitch length is 2 mm, it is
possible to sew approximately 1,000 mm (1 m).
This function can perform the automatic one-shot stitching without using the material end sensor
(ED : optional). Therefore, the sewing machine performs the sewing to the last according to the
sewing pattern even if the label is not located at the end of material when the pedal is depressed
once.
To Next Page
Loading...
