– 85 –
1) Exclusive connectors are prepared for connection of
the connector for CP-160.
2) Paying attention to the orientation of the connector
, connect it to connector (CN38) located on the
circuit board. After connecting, securely lock the con-
nector.
(3) Connecting procedure of CP-160
1) Loosen two screws in the front cover of control box
and open the front cover
2) Remove connectors and ground wire of the circuit
board attached to the front cover/
3) Place the front cover at an angle of approximate 45°,
draw it in the direction of arrow, and remove it from
the box main unit.
(Caution) Do not draw the front cover forcibly since
there is the possibility that the click of front
cover is broken.
4) Securely insert CN41 of IPOP circuit board supplied
as accessories to white connector CN41 on the front
cover circuit board from the upper side.
5) Fix IPOP circuit board with two screws supplied
as accessories.
6) Place the front cover at an angle of approximate 45°,
attach it to the box main unit, and attach connectors
and ground wire which have been removed in step
2).
(Caution) When removing IPOP circuit board, turn
OFF the power and remove it after 5 min-
utes or more have passed.
(4) Installation IPOP circuit board
(5) Installation of IP-100E
1) Install operation panel on the machines head us-
ing screws , washers and spring washers
supplied as accessories.
(Caution) Do not disassemble the operation panel
to prevent it from breakage.
2) Set the panel cord same as the other machine head
cords, insert it to CN121 of the control box, and lock
it.
3) Put it together with other machine head cords and
bundle them with clip band .
4) Close the front cover and tighten two screws, while
taking care not to put the cords in the front cover.
45°
CN41
IPOP circuit
board
CN121
To Next Page
Loading...
