– 117 –
No. Description of error detected Cause of occurrence expected Items to be checked
SmartMedia cover open • The SmartMedia slot is open • Close the cover of the slot
E000 Execution of data initialization • When the machine head is changed.
(This is not the error.) • When the initialization operation is executed
E003 Disconnection of synchronizer • When position detection signal is not input • Check the synchronizer connector (CN33,
connector from the sewing machine head synchronizer. CN43) for loose connection and disconnection.
E004
Synchronizer lower position sensor failure
• When the synchronizer has broken. •
Check whether the synchronizer cord has broken
E005
Synchronizer upper position sensor failure
since the cord is caught in the machine head.
E007 Overload of motor • When the machine head is locked. • Check whether the thread has been entangled
• When sewing extra-heavy material beyond in the motor pulley.
the guarantee of the machine head. • Check the motor output connector (4P) for loose
• When the motor does not run. connection and disconnection.
• Motor or driver is broken. • Check whether there is any holdup when turning
the motor by hand.
E008 Machine head connector • When the machine head connector is not • Check the machine head connector (CN32)
failure(Resistance pack) properly read. for loose connection and disconnection.
E011 A SmartMedia card uninserted • A SmartMedia card has not been inserted. • Turn OFF the power.
E012 Read error • Data on a SmartMedia card cannot be read. • Turn OFF the power.
E013 Write error • Data cannot be written into a SmartMedia • Turn OFF the power.
card.
E014 Write protection • The SmartMedia is write-protected. • Turn OFF the power.
E015 Format error • The SmartMedia is unformattable. • Turn OFF the power.
E016 Beyond external media capacity • Short of SmartMedia capacity • Turn OFF the power.
E019 Beyond file size • The file is too large. • Turn OFF the power.
E032 File compatibility error • The file is not compatible. • Turn OFF the power.
E302 Tilt detection • When tilt detection switch is inputted with • Check whether machine head is tilted without
(MF : thread trimmer knife sensor) the power ON. turning OFF the power switch (operation of
(At the time of safety switch • Position of thread trimmer knife is improper. sewing machine is prohibited for safety).
operation) •
Check whether tilt detection switch cord is caught
in the machine.
• Check whether tilt detection switch lever is
caught in the machine.
E331 Tape cutter (TC03) • Defective cutter sensor • Is air pressure appropriate?
Cutter sensor simultaneously
enabled
E332 Tape cutter (TC03) • Defective assembly • Is air pressure appropriate?
Cutter sensor simultaneously
disabled
E499 Simplified program data error • Command parameter data is out of the range. • Enter the simplified program again.
• Disable the simplified prgram.
E704 Type error of simplified program • Adifferent type is entered for the program • Turn off the power.
or sewing machine data or data.
E730 Encoder failure • When the motor signal is not properly • Check the motor signal connector (CN30) for
E731 Motor hole sensor failure inputted. loose connection and disconnection.
• Check whether the motor signal cord has broken
since the cord is caught in the machine head.
E733 Motor reverse rotation The motor rotates at the speed of more than • Encoder wiring of the main shaft motor is
500rpm in a direction opposite to that of wrong.
indication. • Power wiring of the main shaft motor is
wrong.
(1) Error code list
*
*
*
*
*
*
*
*
*
(Caution) Items marked with * are applicable only to IP-100E.
To Next Page
Loading...
