– 7 –
Teaching switch Unused
Information switch This is the switch to perform various function settings.
Material edge sensor Rendered effective when the material edge sensor is installed on the machine.
switch Used for selecting whether or not the material edge sensor is used during sewing.
One-shot stitching When this switch is set to effective, the sewing machine automatically operates
switch up to the specified number of stitches.
With/without automatic When this switch is set to effective, the sewing machine automatically performs
thread trimmer switch thread trimming when the specified number of stitches has been completed.
Thread trimming This switch prohibits all thread trimmings.
prohibiting switch*This switch cannot be used with the sewing machine which is not provided
with the automatic thread trimming device.
Counter value setting This is the switch to set the value of bobbin thread counter of No. of pcs. counter.
switch
Max. speed limitation variable When moving the resistor in the left direction, max. speed is limited.
resistor
Power display lamp This lamp lights up when the power switch is turned ON.
Smart media cover This is the cover for smart media inserting opening.
To open the cover, place your finger on the notch located on the side of the cover
as shown in the figure and push the cover in the direction of left slanting rear.
* There are some functions that are not able to be operated with the cover opened.
Do not close the cover unless smart media is completely inserted.
Smart media slot To set smart media, insert smart media into smart media slot and push it until it is
(Smart media inserting opening) almost hidden.
To remove smart media, push it further again and it protrudes to the posi
tion where it can be held between your fingers. Now, draw it out.
*Be very careful of the inserting direction of smart media.
To Next Page
Loading...
