– 52 –
Operating procedure of the sewing pattern
1. Reverse stitching pattern
Reverse stitching patterns below can be set by using the operation panel.
Reverse stitching patterns that can be set
Reverse stitching
at start display
Sewing pattern
Reverse stitching
at end display
[ Setting procedure of the reverse stitching ]
(1) Hold pressing / switch , and press
/ switch to select the reverse
stitching pattern.
(Every time / switch is pressed,
reverse stitching pattern/overlapped stitching pat-
tern change over alternately.)
(2) Press / switch to make reverse stitching
at start display flash on and off.
Every time / switch is pressed, the
flashing position shifts in the right direction.
(Caution) The sewing machine does not start in the
flashing state.
(3) Press switch or switch and select
the reverse stitching pattern.
Reverse stitching patterns and displays are as fol-
lows.
: Reverse stitching
: Double reverse stitching
: Without reverse stitching
(4) Press / switch to make reverse stitching
at end display flash on and off, and set the pat-
tern in the same way as step (3).
Flash
Flash
⇔
Reverse stitching pattern
Overlapped stitching pattern
Shift direction
Contents of reverse
stitching selection
updating with switch
updating with swith
To Next Page
Loading...
