JUKI SC-510 Series - Page 71

– 65 –
88
88
8 Selection of the optional input/output function (Function setting No. 12)
Operation keys array
1. Select function No. 12 with the operating procedures described in the
item of how to change over the function setting mode (1) to (4).
Select the items of “End”, “in” and “ouT” with keys and .
[When “in” is selected]
The port Nos. are displayed in the left 3 digits. Designate the input port with
key or . Designate the function of input port with key or .
The function code and the abbreviation are alternately displayed in the 4-
digit LED.(For the relation between signal input No. and connector pin array,
refer to the separate list.)
[When “ouT” is selected]
The port Nos. are displayed in the left 3 digits. Designate the output port with
key or . Designate the function of output port with key or .
The function code and the abbreviation are alternately displayed in the 4-
digit LED. (For the relation between signal input No. and connector pin array,
refer to the separate list.)
(Caution) Note that the voltage used in output function should not exceed the voltage set with W1 and
W2.
* Example) Setting the thread trimming function to the optional input port 1
1. Select function No. 12 with the operating procedures described in the
item of how to change over the function setting mode (1) to (4).
2. Select the item of “in” with keys and .
3. Select the port of 901 with key .
4. Select the thread trimming function, “TSW” with keys and .
5. Determine the thread trimming function, “TSW” with key .
6. Set ACTIVE of the signal with keys and .
Set the display to “L” when the signal is “Low” and performing thread
trimming, and set the display to “H” when the signal is “High” and per-
forming thread trimming.
7. Determine the aforementioned function with key .
8. Finish the optional input with key .
9. Select the item of “End” with keys and to return to the function
setting mode.
* For the other optional function, it is possible to program simple input/output sequence control.
1
2
O
P
T
0
9
0
E
n
d
i
n
o
u
T
*
*
*
9
0
1
<?
9
0
8
*
*
*
9
1
1
<?
9
1
8
T
P
O
1
2
n
9
i
0
0
p
o
n
9
0
1
W
1
9
0
T
L
4
S
[\
Lighting alternately
4
1
9
0
L
H
4
[\
0
2
n
o
p
0
9
9
0
i
n
d
n
E
Optional input 1 to
8 are displayed
Optional input 1 to
8 are displayed