Closed stainless steel bath tanks
9.2 Bath fluids
Danger of burns and property damage if unsuitable bath
fluid is used.
• Only use thermal oils which are recommended by JULABO. The
viscosity of the oil is tailored to the pump capacity.
• Refer to the safety data sheet of the bath fluid, particularly its
flash point.
• Set the excess temperature protector correctly.
• Always store bath fluid so that it cannot harm the environment.
Water as the bath fluid
If you use water as the bath fluid
Recommended water mixture:
70 % soft/decalcified water and 30 % tap water for a temperature
range from 5 °C to 80 °C.
The parts of the bath which come into contact with the bath fluid
may be damaged and cause the failure of the device.
The water quality depends on the local conditions.
• Hard water is not suitable for temperature control tasks due
to its high lime content and will produce lime deposits in the
bath.
• Ferrous water can cause corrosion, even on stainless steel.
• Chloric water can cause pitting corrosion.
• Distilled and deionized water is not suitable. Their specific
properties cause corrosion in the bath, even on stainless steel.
Check the quality of the water you use at regular intervals.
Evaporation and constant refilling may produce a
concentration of harmful substances in the bath.
You should therefore check the quality of the water in the
bath at regular intervals.
Replace the water in the bath in full at regular intervals.
Water bath protection products
The water bath protection product "Aqua-Stabil" is recommended to
combat algae, bacteria and fungus formation.
Order No. Designation
8 940 006 6x 100 ml bottles
8 940 012 12x 100 ml bottles
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
