EasyManua.ls Logo

Julabo CORIO CD - Safety Instructions

Julabo CORIO CD
67 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Safety instructions
5 Safety instructions
It is important to follow these safety instructions to prevent personal
injury and property damage. These instructions apply in addition to
standard safety practices for working places.
It is essential that you read the user information before starting the
unit.
Use PPE (safety gloves, safety shoes, safety goggles).
Transport the unit carefully. The interior of the unit can also be
damaged by impacts or if it is dropped.
Do not loiter under the unit during transportation and operation.
The unit is not intended for use in potentially explosive areas.
Please observe the specifications for the minimum space
requirement when setting up the unit.
Only operate the unit in rooms that are well-ventilated, dry and free
of frost.
Switch the unit off immediately if there is refrigerant leakage.
Place the unit on a flat surface of non-flammable material.
Operate the unit under an exhaust hood as much as possible.
Do not start the unit if it is damaged or leaking.
Compare the mains voltage and frequency with the specifications on
the type plate.
Only connect the unit to a fused mains connection via a FI circuit
breaker (Ia=30 mA).
Only connect the unit to a power socket with ground contact (PE
protective earth)!
The power supply plug serves as safe disconnecting device from the
power supply network and must be freely accessible at all times.
Check the mains cable regularly for signs of damage.
Do not start the unit if it has a damaged power cable.
Keep the mains cable away from hot pump connections.
Refer to the safety sticker. Parts of the unit can be hot or cold.
Never use the unit without bath fluid.
Do not reach into the thermal bath fluid.
Check the filling level of the bath fluid at regular intervals. The pump
and heater must always be completely covered with bath fluid.
Adjust over-temperature safety device below the flash point of the
bath fluid.
Consider the restricted working temperature range if you are using
plastic bath tanks.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com

Other manuals for Julabo CORIO CD

Related product manuals