8 Preparations for operating the device
8.1 Securing the immersion circulator
Danger of electric shock.
Carefully secure the immersion circulator on the bath vessel. Poorly
installed circulators can fall into the bath tank.
Have the unit checked by a service technician prior to re-use.
The heater must not be in contact with the wall or the bottom of the
bath tank. Minimum distance 15 mm.
Pull the plug to disconnect the unit from the power supply. Only then
take the immersion circulator out of the bath tank.
A range of accessories is available for various applications:
• Bath clamp (for securing the circulator to baths)
• Bracket (for securing the circulator to JULABO refrigeration
machines)
• Pump set (for connecting external applications)
• Cooling coil (for operating close to ambient temperature)
• Stand holder with rod (for securing to a laboratory stand)
Bath attachment clamp, order No. 9970420
• Pay special attention to the circulator's immersion depth (see
Technical data) when selecting the bath.
• Place the bath on a flat surface on a pad made of non-flammable
material.
• Secure the bath attachment clamp to the bath tank. The wall
thickness may be up to 30 mm.
• Attach the circulator with a “click” to the bath attachment clamp.
Stand attachment, order No. 9970022
For use with glass tanks a stand attachment with rod is available as
an optional accessory.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
