Julabo ME - 7.2. Direct setting of temperatures

ME
23
7.2. Direct setting of temperatures
The circulator uses the setpoint of SETPNT 1 or 2 or 3 for temperature
control
The indicated setpoint temperature can be changed directly any time.
Example: change 25.00 °C to 50.00 °C
1. By pressing the key
the circulator switches to the active
SETPOINT< example on the left: >SETPNT / 1 25.00°C<.
The integer digits flash
(example: <25>).
2. By pressing the keys
and the value is changed to
50.00 °C and
is confirmed by pressing the
key.
The decimal digits flash and can be adjusted if desired.
Confirm once more by pressing the
key.
L The circulator uses the new working temperature value for temperature
control.
L The temperatures can be set in start or stop mode.