JUMO diraTRON 108 User Manual

9 Online parameter (setup only)
86
9.3 Calibrate/test
Hardware/software
The device's hardware and software status is displayed in this window.
Calibration constants
This window displays the calibration constants for the analog input and output.
Analog input
This function tests the analog input. To allow this to happen, the signal or resistance must be in place at
the analog input.
After selecting the corresponding signal type and pressing the "Test" button, the value at the analog input
is continuously measured and displayed in the "Act. value" (last value) field as well as in the display field
(left; all measured values). The continuous measurement is terminated by pressing "Stop".
Analog output
This function tests the analog output. The signal at the analog output must be measured for this purpose.
Action Version Description
Generate code number To generate a code number, click the
function to select it and then click the
"Next" button. Follow the other in-
structions on the screen.
This function is used to generate a
code number to enable an extra
code. The code number is required to
obtain an activation code from a sales
partner.
Enter activation code To enter an activation code, click the
function to select it and then click the
"Next" button. Follow the other in-
structions on the screen.
This function is used to activate an
extra code. This requires the activa-
tion code received from the sales
partner.
Reset extra codes To reset extra codes, click the func-
tion to select it and then click the
"Next" button. Follow the other in-
structions on the screen.
This function can be used to lock an
extra code that has been activated.
Locked extra codes can only be acti-
vated by re-enabling. This procedure
is subject to charge.

JUMO diraTRON 108 Specifications

General

Brand	JUMO
Model	diraTRON 108
Category	Controller
Language	English