19
3 Installation
3.1 General information on installation
Mounting site
The device is designed for installation in a panel cut-out. The front of the device and housing
have different protection types (see technical data).
Climatic conditions
The ambient temperature and the relative humidity at the mounting site must correspond to the
technical data. Aggressive gases and vapors have a negative effect on the operating life of the
device. The mounting site must be free from dust, powder, and other suspended matter.
Installation position
The installation position is not specified, however the screen view angle must be taken into con-
sideration (see technical data).
Technical data
Chapter 6.1 "Technical data", page 69
3.2 Dimensions
Device
WARNING!
The device is not designed for use in potentially explosive areas.
There is the risk of an explosion.
Only deploy the device outside of potentially explosive areas.
To Next Page
Loading...
