JUMO LOGOSCREEN nt - Introduction

7
1 Introduction
1.1 Preface
Please read this manual before commissioning the instrument. Keep the
instructions in a place which is accessible to all users at all times.
Please assist us in improving these instructions where necessary.
Your comments will be appreciated.
H
If any difficulties should arise during commissioning, you are asked
not to carry out any manipulations that could endanger your rights
under the instrument warranty!
Please contact the nearest subsidiary or the head office in such a
case.
E
When returning modules, assemblies or components, the
regulations of EN 61340-5-1 and EN 61340-5-2 “Protection of
electronic devices from electrostatic phenomena” must be
observed. Use only the appropriate ESD packaging for transport.
Please note that we cannot accept any liability for damage caused
by ESD.
ESD = Electro Static Discharge
B