E 13
0705.USA
2.3 Raising and lowering load units
IMPORTANT Before lifting a load unit, the driver must be sure that it is palleted correctly
and does not exceed the permitted load capacity of the vehicle.
– Move the vehicle's fork arms as far as possible under the load unit. Long goods
must not be picked up transversely.
IMPORTANT The load unit must be picked up so that it does not project significantly
(< 2 inches (50 mm)) beyond the tips of the fork arms.
Raising and lowering
NOTICE The fork is raised or lowered at a predefined speed by pressing the "Up" or
"Down" buttons.
Raise
– Press the "Up" rocker switch (9). Hold down the rocker switch until the lift height is
reached.
Lower
– Press the "Down" rocker switch (8) to lower the fork.
98
9 8
To Next Page
Loading...
Need help?
General
